Chapter 3: Preparing For Fiery Setup; Levels Of Access And Control; Fiery Print Connections - Sharp AR-C360P Software Configuration Manual

3

3-49 Levels of access and control

Chapter 3:
Preparing for
Fiery Setup
'To prepare for printing at your site, you must do some initial Fiery
configuration, or Setup, to specify the network environment and
the kind of printing you will do. Before you perform Setup, you
must decide the levels of access you will implement for your site.
Administrators and operators must also understand how Fiery
system software is structured in order to configure and use the
Fiery system correctly.
Levels of access and control
When you configure the Fiery during Setup, you (as system
administrator) implement a particular level of control by enabling
or not enabling print connections, passwords, and access to
WebTools. The level of control you implement can range from
minimum to moderate to maximum—or none at all.
• Minimum control might be appropriate for a small site where
anyone on the local network can control all printing and Fiery
functions. Although there may be an administrator or operator
charged with certain duties, all users have equal access to the
system and job management tools.
• Maximum control might be appropriate for a high-volume
printing environment where an administrator or operator
controls the job flow and all printing; jobs sent by users are
spooled (stored) to the Fiery hard disk until the operator decides
it is time to print them. In addition, only the administrator and
operator have access to job management tools. This is the
recommended level of control.
The term "job management tools" is used in this manual to
Note:
refer to Command WorkStation and Command WorkStation LE.

Fiery print connections

The Fiery supports three print connections: Hold queue, Print
queue, and Direct connection. These print connections can be
enabled, or "published," to users on the network when you
Sharp AR-C360P EFI Configuration Guide - 49