Sharp AR-C360P Software Configuration Manual page 28
Efi configuration guide
Hide thumbs
Also See for AR-C360P:
- Job management manual (220 pages) ,
- Utility manual (188 pages) ,
- Service manual (180 pages)
Table of Contents
Advertisement
2
2-28 Setting up Network Servers
Configuring a Windows NT 4.0/2000/Server
2003 server to
communicate with the Fiery
To configure a Windows NT 4.0/2000/Server 2003 server to
communicate with the Fiery, follow these general steps. More
detail is provided in subsequent sections in this chapter and in
your Microsoft documentation.
•
Load the TCP/IP network protocol on the server and configure it
with an IP address, subnet mask, and gateway.
•
Enter the host name of the Fiery in the host name database used
by your system (see
•
Perform Fiery Setup.
•
On the Windows NT 4.0/2000/Server 2003 server, create a
printer for each Fiery print connection, install the appropriate
printer drivers, and (optionally) share the printer on the network
(see
page
•
Enter the host name and remote printer name of the Fiery in the
printer connection. For more information, see
•
If the Windows NT 4.0/2000/Server 2003 server is also a
workstation, install Fiery utilities (see the User Software
Installation Guide).
Sharp AR-C360P EFI Configuration Guide - 28
page
2-29).
2-30).
page
2-45.
Advertisement
Table of Contents
