Table of Contents
Advertisement
Then, connect the bottom end of the
molded hose to the dispensing unit.
Insert the milk pipework into the milk
valve on the left and right-hand sides.
Push the connecting pieces into the
silicone seal as far as they will go.
Check that the milk pipework is snug
against the housing and that the
cover can be easily attached.
Tip: If necessary, screw the milk
pipework backward at the connecting
piece on the right-hand side.
Attach the milk valve cover as
follows: insert the pin in the top right-
hand corner and swivel the cover
backward until a proper fit is
achieved.
Cleaning and care
Push the left-hand bean container
and maintenance container back into
the coffee machine.
Attach the central spout's stainless
steel cover.
Close the appliance door.
You can now switch the coffee machine
back on.
Cleaning the bean containers
Risk of damage from incorrect
use and cleaning.
Immersing the bean containers in
liquids can result in malfunctions. If
they are taken apart, bits may break
off or the mechanism may no longer
work properly once they are
reassembled.
Do not disassemble the bean
containers.
Do not immerse the bean containers
in liquids, e.g., soapy water.
Coffee beans contain oils which can
deposit on the walls of the bean
containers and hinder the flow of the
beans. Therefore, clean the bean
containers at least once a month with a
soft cloth.
If required, you can clean the lids of the
bean containers by hand with a mild
solution of warm water and liquid dish
soap. Dry the lids thoroughly before
replacing them on the bean containers.
Open the appliance door.
Pull the left and right-hand bean
containers out of the coffee machine.
Clean the bean container wells inside
the machine.
73
Advertisement
Table of Contents
