Installing The Solid-State Drive - Lenovo 10HJ User Manual

10. Note the orientation of the new microprocessor. Hold the new microprocessor by its edges and align
the notches 1 on it with the tabs
microprocessor straight down into the microprocessor socket.
Note: The small triangle
indicator. The new microprocessor is in the correct orientation when this indicator points to the beveled
4
corner of the microprocessor socket.
Figure 27. Installing the microprocessor
11. Close the microprocessor retainer and lock it into position with the small handle to secure the new
microprocessor in the socket.
12. Reinstall the heat sink and fan assembly. See "Replacing the heat sink and fan assembly" on page 50.
13. Reconnect all cables that were disconnected from the system board.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to "Completing the parts replacement" on page 73.

Installing the solid-state drive

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to install the 2.5-inch solid-state drive.
To install the solid-state drive, do the following:
56
ThinkCentre M73 User Guide
2 in the microprocessor socket. Then, carefully lower the new
3 on one corner of the new microprocessor is the microprocessor orientation