Table of Contents
Advertisement
WARNING:
Before working inside your tablet, read the safety information that shipped with your tablet and follow the steps in
Before working inside your
more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
NOTE:
Your tablet's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup program after
you replace the system board.
NOTE:
Replacing the system board removes any changes you have made to the BIOS using the BIOS setup program. You must
make the desired changes again after you replace the system board.
Topics:
•
Procedure
•
Post-requisites
Procedure
1
Align the screw holes on the system board with the screw holes on the back-cover assembly.
2
Replace the screws that secure the system board to the back-cover assembly.
3
Align the screw holes on the I/O bracket with the screw holes on the system board.
4
Replace the screws that secure the I/O bracket to the system board.
5
Slide in the headset-port cable, power-button board cable and display assembly cable into the respective connectors on the system
board and press down the latches to secure the cables.
6
Connect the speaker cables, camera cables, microphone cable, and coin-cell battery cable to the respective connectors on the system
board.
Post-requisites
1
Replace the
wireless
card.
2
Replace the
solid-state
drive.
3
Replace the battery.
Replacing the system board
tablet. After working inside your tablet, follow the instructions in
After working inside your
tablet. For
Replacing the system board
26
37
Advertisement
Table of Contents
