Table of Contents
Advertisement
DIMM sockets
This motherboard supports DDR400/333/266 with Maximum capacity up to 2GB (When enabling VGA
onboard, memory can run max. up to 333MHz). Only Non-ECC DDR RAM is supported, otherwise, it
will cause serious damage on memory sockets or SDRAM module. For over clocking purpose, you can
adjust memory voltage in BIOS from 2.5V to 2.65V.
JP14 Clear CMOS
You can clear CMOS to restore system default setting. To clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
CPU and System Fan Connector
Plug in the CPU fan cable to the 3-pin CPUFAN1 connector. If you have chassis fan, you can also plug
it on SYSFAN2 or SYSFAN3 connector.
1
1
Normal
Clear CMOS
(default)
Pin 1
SYSFAN3 connector
SYSFAN2 connector
CPUFAN connector
39
DIMMB1
DIMMA1
GND
+12V
SENSOR
Advertisement
Table of Contents
