Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Cornelius Enduro 175 8 Valve
Summary of Contents for Cornelius Enduro 175 8 Valve
- Page 1 ICE/BEVERAGE DISPENSER MODEL: ENDURO-175 8 VALVE OPERATOR’S MANUAL Release Date: March 1, 2004 Publication Number: 620917901OPR Revision Date: August 3, 2010 Revision: C Visit the IMI Cornelius web site at www.cornelius.com for all your Literature needs.
-
Page 2: Contact Information
Commercial Warranty. Cornelius will not be responsible for any repair, replacement or other service required by or loss or damage resulting from any of the following occurrences, including but not limited to, (1) other than normal and proper use and normal... -
Page 3: Table Of Contents
Safety Instructions..............1 Read and Follow ALL Safety Instructions . -
Page 5: Safety Instructions
Only trained and certified electrical, plumbing and refrigeration technicians should service this unit. ALL WIRING AND PLUMBING MUST CONFORM TO NATIONAL AND LOCAL CODES. FAILURE TO COMPLY COULD RESULT IN SERIOUS INJURY, DEATH OR EQUIPMENT DAMAGE. © 2004-2010, IMI Cornelius Inc. Ice/Beverage Dispenser Operator’s Manual AFETY... -
Page 6: Safety Precautions
Publication Number: 620917901OPR ARNING OUNTER - 2 - gas leaks in the entire CO © 2004-2010, IMI Cornelius Inc. -
Page 7: Start-Up And Operating Instructions
© 2004-2010, IMI Cornelius Inc. Ice/Beverage Dispenser Operator’s Manual F. This could cause damage to the unit. -
Page 8: Cleaning And Maintenance Instructions
Ice/Beverage Dispenser Operator’s Manual CLEANING AND MAINTENANCE INSTRUCTIONS These instructions are used on all Cornelius ice drink dispensers. Some models may have additional cleaning requirements. Those models will have addition procedures listed later in the manual. WARNING: Disconnect power to the unit before cleaning or servicing following all lock out / tag out procedures established by the user. -
Page 9: Yearly Maintenance
IMPORTANT: Only trained and qualified persons should perform these cleaning and sanitizing procedures. Sanitize Pre-Mix And Post–Mix Tank System 1. Remove all the quick disconnects from all the tanks. Fill a suitable pail or bucket with soap solution. © 2004-2010, IMI Cornelius Inc. Ice/Beverage Dispenser Operator’s Manual - 5 -... -
Page 10: Sanitize Syrup Lines, B-I-B Systems
2. Slowly loosen the CO regulator assembly coupling nut allowing CO regulator assembly from the empty CO Publication Number: 620917901OPR cylinder valve. cylinder - 6 - system. cylinder”) portion of the pressure to escape, then remove the © 2004-2010, IMI Cornelius Inc. - Page 11 (back-seating the valve prevents gas leakage around the valve shaft). 7. Check CO connections for leaks. Tighten any loose connections. © 2004-2010, IMI Cornelius Inc. Ice/Beverage Dispenser Operator’s Manual cylinder cylinder with a safety chain to prevent it...
-
Page 12: Troubleshooting
No 24 volt power to PC board. No CO2 pressure. C. Empty syrup tank. Kinked tubing. Clogged inner nozzle. Defective PC board. G. Defective harness from keypad. H. Defective Flow control. Defective solenoid harness. Defective keypad - 8 - © 2004-2010, IMI Cornelius Inc. - Page 13 FLAVOR DISPENSES MORE THAN .5 OZ. Contact your local syrup or beverage equipment distributor for additional information and troubleshooting of beverage system. © 2004-2010, IMI Cornelius Inc. Ice/Beverage Dispenser Operator’s Manual Dip switch settings on control board incorrect. PC board defective.
- Page 14 Ice/Beverage Dispenser Operator’s Manual Publication Number: 620917901OPR - 10 - © 2004-2010, IMI Cornelius Inc.
- Page 16 IMI Cornelius Inc. www.cornelius.com...