Table of Contents
Advertisement
2.15 Fast Action Buttons
RUN/STOP: Continuously acquire waveforms or stop the acquisition.
SINGLE SEQ: Acquire a single waveform and then stop the acquisition.
AUTOSET: Automatically set the oscilloscope controls to generate a usable display of the input
signals. Refer to the following table for relative content.
2.15.1 Autoset
Autoset is one of the advantages digital oscilloscopes have. When you push the AUTOSET button,
the oscilloscope will identify the type of waveform (sine or square wave) and adjust controls
according to input signals so that it can accurately display the waveform of the input signal.
Functions
Acquire Mode
Cursor
Display Format
Display Type
Horizontal Position
SEC/DIV
Trigger Coupling
Trigger Holdoff
Trigger Level
Trigger Mode
Trigger Source
Trigger Slope
Trigger Type
Trigger Video Sync
Trigger Video Standard
Vertical Bandwidth
QC1936 Digital Storage Oscilloscope
Adjusted to Normal or Peak Detect
Off
Set to YT
Set to Vectors for an FFT spectrum; otherwise, unchanged
Adjusted
Adjusted
Adjusted to DC, Noise Reject or HF Reject
Minimum
Set to 50%
Auto
Adjusted; Autoset can not be used for the EXT TRIG signal
Adjusted
Edge
Adjusted
Adjusted
Full
Settings
Basic Operation
45
Advertisement
Table of Contents
