Multi-Functional Knobs And Buttons; Signal Connectors - DigiTech QC-1936 User Manual

2.2 Multi-functional Knobs and Buttons

V0: Multi-functional knob. Under different menu options, it supports selecting menu
options (MEASURE), moving cursors and levels (Slope Trigger).
Press this knob to reset data (trigger holdoff, overtime of the overtime trigger and
slope trigger), select menu
F7: Push this button in single-window mode to switch between dotted line display
and cross display. Push it in dual-window mode to perform autocruise.
F0: Hide/Show
screen and give a full screen display of waveforms. Push it again to show the menu
options.
F1-F5: These five buttons are all multi-functional. They are in charge of selecting
corresponding menu options on the screen in different menu modes. For example, in
the UTILITY menu, F1-F5 respectively correspond to 'System Info' – 'Advance'.
F6: This functional button is mainly used to turn pages and confirm a selection, such
as 'next page', 'previous page', and 'press F6 to confirm' appearing when you push
Self Calibration option.

2.3 Signal Connectors

See the figure below to find the seven signals connectors and a pair of metal electrodes at the
bottom of the oscilloscope panel.
1. GEN OUT: Waveform Signal Output.
QC1936 Digital Storage Oscilloscope
options and so on. Easy to operate.
button. Push it to hide the menu options on the right side of the
Basic Operation
8