Menu And Control Keys - DigiTech QC-1936 User Manual

2.1 Menu and control keys

As shown in the figure below:
All the keys are described as follows:

[CH1], [CH2]: display setup menus of channel 1 and channel 2.
 [MATH]: display "ARITHMETICAL OPERATION" and "REFERENCE WAVEFORM" menu.
 [HORIZ]: display "HORIZONTAL" menu.
 [TRIG]: display "TRIGGER" control menu.

[FORCE TRIG]: It is used for finishing acquisition of the current waveform no matter whether
the oscilloscope detects trigger, and it is mainly applied to "NORMAL" and "SINGLE" in the
trigger mode.
 [SAVE/RECALL]: display the "SAVE/RECALL" menu of setups and waveform.
 [MEASURE]: display the "MEASURE" menu.
[ACQUIRE]: display the "ACQUIRE" menu.

 [UTILITY]: display "UTILITY FUNCTION" menu.
 [CURSOR]: display the "CURSOR" menu. The [V0] knob can be used for regulating the
position of the cursor when the "CURSOR" menu is displayed and the cursor is triggered.
 [DISPLAY]: show the "DISPLAY" menu.

[HELP]: enter the on-line help system.

[AUTOSET]: automatically set the control state of the oscilloscope so as to display suitable
waveform.

[RUN/STOP]: continuously acquire waveform or stop acquisition

[SINGLE SEQ]: Acquire a single trigger, finish acquisition and then stop.

[GEN DSO]: Waveform generator output button..

[GEN ON/GEN OFF]: Power Amplifier output button.
QC1936 Digital Storage Oscilloscope
Figure2-1 Control keys
Basic Operation
7