Samsung SNP-3370TH User Manual page 11

Detailed Warnings and Cautions
- Avoid operating the camera for long durations under high temperatures and in high humidity. Excessive heat
can shorten the lifespan of the camera components.
Do not install or place the camera near any heat sources.
- Subjecting the dome cover to physical shock may damage the camera and cause water leakage into it.
- Do not place the camera facing direct sunlight or other intense light sources. Strong lights such as spotlights
can cause distortions—blooming and smear—as well as discolorations on the screen by heating up the color
filter of the camera. They also may cause reflections inside the camera, leading to operational malfunctions.
- Do not drop the camera or subject it to physical shock or vibration; this can cause serious damage to the
camera.
- When installing the camera near a power line, make sure to keep at least 1 meter distance from the power
line, or earth an additional metal pipe to separate the camera from the power source.
- This camera is for installation on a ceiling. Installing it on the ground or in a location that is not level may cause
product malfunctions and shorten its lifespan.
- When installing it in an outdoor environment, use the outdoor housing.
- Avoid installing and operating the camera in the following places.
• P laces where the temperature exceeds the camera's recommended range.
• Places where drastic temperature changes occur: e.g. Near an air conditioner.
• Places that are exposed to steam, oil, and flammable substances: e.g. Inside a kitchen.
• Places that are exposed to radioactivity, X-rays, strong electric waves, and electro-magnetic waves.
• Places that are exposed to outdoor air contaminants: e.g. Dust and car exhaust.
• Places where there is high humidity.
• Places that are exposed to corrosive gas: e.g. Near the sea.
- Covers that are dusty or smeared decrease the picture and video quality. Clean the dome cover and camera
lens on a regular basis.
- Remove the plastic wrap on the dome cover only after the camera installation is complete.
- This camera is not equipped with a power switch. Plug in the camera only after the installation is complete.
- The main unit has a large and a small door.
A large door has a 24-pin connector and a small one has a 4-pin connector. Because these are not used for
the product operation, do not connect cables to them. It may result in malfunction.
Caution
• R isk of Explosion if Battery is replaced by an Incorrect Type.
Dispose of Used Batteries According to the Instructions.(See 4 page)
NETWORK PTZ CAMERA
11
User Manual