Vr Heat Sink; Removing The Vr Heat Sink - Dell Alienware Aurora R16 Owner's Manual

Steps
1. Align and place the SMA cable connector on the chassis.
2. Route the SMA cable under the PCIe x16 slot.
3. Insert the SMA cable to the securing clip on the system board.
4. Route the SMA cable assembly through the slot on the rear I/O.
5. Replace the washer and nuts that secure the SMA cable connector to the chassis.
Next steps
1. Install the wireless card.
2. Install the single-graphics
3. Install the left-side cover.
4. Follow the procedure in

VR heat sink

Removing the VR heat sink

CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
NOTE: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
CAUTION: If either the processor or the heat sink is replaced, use the thermal grease that is provided in the kit to
ensure that thermal conductivity is achieved.
NOTE: Do not touch the heat transfer areas on the heat sink. The oils in your skin can reduce the heat transfer capability of
the thermal grease.
card.
After working inside your
Before working inside your
computer.
computer.
87