Step 4: Adjust the air inlet direction
(From rear side to under-side.)
1. Take o the ventilation panel and ange.
Ventilation panel
2. Change the mounting positions of the
ventilation panel and air return ange.
Air return ange
3. When installing the lter mesh, t it into the
ange as illustrated in the following gure.
NOTE: All the gures in this manual are for
demonstration purposes only. The air conditioner
you have purchased may be slightly di erent in
design, though similar in shape.
Page 12
Air return ange
Fig. 4.11
Ventilation panel
Fig. 4.12
Fig. 4.13
Step 5: Fresh air duct installation
Dimension :
Duct joint for fresh air
MODLE
18-60
Ø125mm(4.92")
Step 6: Motor and drain pump maintenance
(the rear ventilated panel is used as an example)
Motor maintenance:
1.
Take o the ventilated panel.
2.
Take o the blower housing.
3.
Take o the motor.
Pump maintainance:
1.
Remove four screws from the drain pump.
2.
Unplug the pump power supply and water
level switch cable.
3.
Detach the pump.
Ø160mm(6.3")
Fig. 4.14
Mofor
Blower housing
Ventilated panel
Fig. 4.15
Pump
Fig. 4.16