Advertisement
ED/DF300 22" CCM322/522 Nordic Style Lid Kit Installation Instructions
4. Seal the icemaker to the top of the dispenser after determining the correct location for the ice maker (see Figure
1).
A. Run beads of RTV around the opening in the lid and inside of the perimeter of the ice maker outline so
that the ice maker will set on the RTV.
B. Set the ice maker onto the lid and position it as required.
C. Wipe away the excess RTV.
5. 5. Drill 0.147" diameter holes into the ice maker cabinet and the dispenser lid using the icemaker mounting brack-
ets as templates. USE CAUTION SO AS NOT TO DRILL INTO ANY ICEMAKER COMPONENTS (CON-
DENSER, TUBING, ETC.). Secure the brackets using the #10 sheet metal screws provided.
6. Install the wire form bracket, supplied with the bin stat kit (item 4), through the 5/8" diameter hole in the bottom of
the ice maker. Wrap the eye of the wireform over the stud near the hole to the end of the wireform bracket and
wrap the tube around the end of the bracket several times, insuring the tube is secure.
NOTE: The bin stat must not interfere with the agitator rotation or in the path of ice falling from the ice-
maker. If it interferes with the agitator or in the path of ice, bend the bracket out of the way.
IMPORTANT: Do not use the spacers provided for mounting the bin thermostat capillary tube to
the Icemaker base.
7. 7. Locate the cleaning caution label (item 5) on the manual ice fill cover (item 4) as shown in Figure 1. Place the
manual fill cover in position over the flange on the lid assembly and the front access hopper opening.
8. The unit is now ready for operation.
Publication Number: 620204725INS
Figure 1. ED/DF300 Kit
- 2 -
© 2007-2010, IMI Cornelius Inc.
Advertisement
