Sharp Notevision XG-PH50X-NL Setup Manual page 52

Sharp notevision xg-ph50x-nl: setup guide
Hide thumbs Also See for Notevision XG-PH50X-NL:
Table of Contents

Advertisement

Troubleshooting
\ Check if the "TCP/IP" protocol is operating correctly using the "PING" command. Also, check
if an IP address is set.
1. Open a command prompt (MS-DOS Prompt).
2. After launching the command prompt (MS-DOS Prompt) enter a command "PING".
3. When connecting normally, the display will be as follows.
4. When a command cannot be sent, "Request time out" will be displayed.
5. To return to the Windows
A connection cannot be made because you have forgotten your user name or your password.
\ Initialize the settings. (See page 88 of the projector's operation manual.)
\ After the initialization, carry out setting again.
-52
• In the case of Windows
order.
• In the case of Windows
Prompt" in order.
• In the case of Windows
Prompt" in order.
XP: click "start" ➔ "All Programs" ➔ "Accessories" ➔ "Command
®
• In case of Windows
Prompt" in order.
Entry example C:\>Ping XXX.XXX.XXX.XXX
"XXX.XXX.XXX.XXX" should be entered with an IP address to be connected to, such as
the projector.
(The screen may be slightly different depending on the OS type.)
<Example> when the IP address connected to is "192.168.150.2"
Check the network setting again.
If communication can still not be established properly, contact your network administrator.
98 or 98SE: click "start" ➔ "Programs" ➔ "MS-DOS Prompt" in
®
Me: click "start" ➔ "Programs" ➔ "Accessories" ➔ "MS-DOS
®
2000: click "start" ➔ "Programs" ➔ "Accessories" ➔ "Command
®
®
screen, enter "exit" and then press the "Enter" key.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Notevision XG-PH50X-NL and is the answer not in the manual?

This manual is also suitable for:

Xg-ph50x

Table of Contents