Table of Contents
Advertisement
Setting the power save modes
The time that elapses before the copier enters a power save mode after any
operation is made can be set manually. This time is set with user program No.
2 for the preheat mode and user program No. 3 for the auto power shut-off
mode. For these settings, see page 32.
The copier will enter the preheat mode first and then the auto power shut-
off mode after a preset time has elapsed when no copier operation has been
made.
If conflicting settings are made with user programs No. 3 and No.5, the last
program set will have priority.
Copying from the preheat mode
Make desired copier selections and press the START
(
) key using the normal copying procedure.
When any key input is made or any other copier operation is made, the
POWER SAVE (
) indicator will start to blink.
When the START (
indicator will go out and copying will start within 10 seconds. The
POWER SAVE (
) indicator will go out when copying starts.
POWER SAVE MODES
) key is pressed, the START key (
)
41
Advertisement
Table of Contents
