Table of Contents
Advertisement
Care and Cleaning
! Never use steam cleaners or pressure cleaners on
the appliance.
Clean the glass part of the oven door using a sponge
!
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could
scratch the surface and cause the glass to crack.
The accessories can be washed like averyday
!
crockery (even in your dishwasher).
! Switch off the electricity supply and allow to cool
before cleaning the cooker.
! Clean the cooker regularly and wipe up spills soon
after they occur to prevent them from becoming
burnt on. Never use biological washing powder,
caustic cleaners, harsh abrasives, scouring pads,
steam cleaners, aerosol cleaners or oven chemical
cleaners of any kind.
! If it is necessary to remove the cooker for
cleaning, ensure that it is cool and beware that it is
heavy (approximately 70 kg 155 lbs).
! To move the cooker forward, open the top oven/grill
door and with both hands positioned under the roof
of the compartment, lift and pull forward. Replace by
pushing the cooker backwards.
! Check that the cooker is level. Take care not to
damage any floor coverings.
COOKER FINISH
Vitreous Enamel
Door inner panels, pan supports, burner caps,
roasting dish, grill pan, main oven base, inside of
grill compartment.
Hotplate
Paint
Side panels.
Control panel, lid front trim
Aluminium
Hotplate burner bodies, lid rear trim.
Glass
Chromium Plating
Oven shelves, grill pan grid, grill pan handle
support.
Plastic
Control knobs.
Stainless Steel
Hotplate, control panell, grill pan handle,
*Concerns certain models only
Oven Shelf Supports*
Oven Shelf Supports
Oven Shelf Supports
Oven Shelf Supports
The shelf supports are removable and dishwasher
safe.
To remove
To remove hold the support at the front lift and pull
To remove
To remove
To remove
a sink or a dishwasher. When removed it allows
access to the oven side, which can be cleaned with
warm soapy water.
To refit the support, insert the longer leg into the
To refit
To refit
To refit
To refit
rear fixing hole and push in the front leg.
REPLACEMENT OF OVEN LIGHT BULB
CAUTION: DISCONNECT THE APPLIANCE FROM
THE ELECTRICITY SUPPLY BEFORE
REPLACING THE LAMP TO AVOID THE
POSSIBILITY OF AN ELECTRIC SHOCK.
Light bulbs are not covered by the manufacturer's
guarantee.
A new 25W, 300°C rated SES bulb can be obtained
from your cooker supplier or any major electrical
retailer.
1. Remove the shelves from the oven.
2. Unscrew the lens using a thick cloth to protect your
fingers in the unlikely event of a lens fracture.
3. Unscrew bulb.
4. Fit new bulb and refit lens.
CLEANING METHOD
Cloth wrung out in warm soapy water. Stubborn stains can be remo-
ved with a cream paste, liquid cleaner or by rubbing with fine steel
wool soap pads.
Check that the cleaning agent is approved by the Vitreous Enamel
Association.
Wash with a cloth wrung out in warm soapy water only.
DO NOT USE ABRASIVES.
Similar to paint cleaning above. Use a nylon brush to remove any
cleaning materials, water or dirt from the hotplate burner bodies.
As for enamel cleaning. Polish with a clean dry cloth or kitchen roll.
Wipe with a cloth wrung out in warm soapy water. A fine steel wool
soap pad e.g. Brillo, Ajax, or a chrome or stainless steel cleaner
may be used.
Wipe with a cloth wrung out in warm soapy water.
Wipe with a cloth wrung out in warm soapy water. Polish with a cle-
an dry cloth or kitchen towel. For stubborn stains, use a proprietary
stainless steel cleaner and follow the instructions on the container.
GB
19
Advertisement
Table of Contents
