Formax FD 300 Operator's Manual page 6

Setting Outfeed Stacker Wheels
1. A zip tie is used to hold the outfeed wheels in place during shipping. Cut and remove the tie before
proceeding. Adjust outfeed wheels to match the fold type and paper size. NOTE: This is important for
proper outfeeding. Loosen the thumbscrew and slide the tires up or down to the correct position.
Refer to the guide at right for the correct position. Tighten the thumbscrew to hold the tires in place.
Zip Tie
Loading Paper and Adjusting Side Guides
1. Load the paper by pressing down on the spring-loaded infeed guide. Be sure the leading edge of the
paper is under the feed tires.
2. After loading the paper, adjust the side guides by gently pinching them and sliding them inward toward
the paper stack. Be sure they are snug against the paper stack, then loosen slightly to leave a gap of
approximately 1mm on each side. The paper should lie flat.
Stacker Wheel Position
Fold Type
Letter "C"
Accordion "Z"
Double Parallel
Half "V"
5
LT (11") LGA (14")
3 2
3 2
4 3
1 0