Table of Contents
Advertisement
Appliance details
2.6
Heater Placement and Clearances
The 2400 EO is design certified for installation directly
on a combustible wall. (see 2.7 Mounting installation)
For installation on vinyl siding see Fig. 10. Keep the area
below the heater free of combustible material.
Minimum clearances
If the appliance is installed under an overhang, there
must be a 36" clearance from the top of the appliance
and the mounting area must be open in front and on the
sides of the appliance.
Fig. 5
Danger: The top of the kit will get hot
due to the flue gases. Install away from
children.
Ref.
Description
A
Directly below or from an
opening; operable windows,
B
doors and any fresh air
C
openings
From any adjacent wall or tall
D
shruberry
Below a gutter, sanitary
E
pipework, eaves or overhang
F
Above ground
From a gas meter, gas
G
regulator, electrical box or
another 2400EO heater
Table 2 Clearances
8
2.7
i
To remove front cover.
B Loosen the two Philips head screws located on front
panel (beneath plastic decal shields if they are
already attached, see Fig. 6).
Min.
distances
≥ 4 ft
Fig. 6
B Remove the two top screws securing the vent cap to
the top of the heater, being careful the washers on
≥ 4 ft
the screws are not lost, see Fig. 7.
≥ 3 ft
≥ 1 ft
≥ 3 ft
Fig. 7
B Lift the top vent cap completely upward from the
heater.
B From the bottom of the heater, holding the sides, lift
the front cover panel of the heater upward and
slightly toward you to remove.
Mounting installation
Warning: before starting installation:
B check that there are no loose parts
inside the appliance
B ensure that gas pipe, gas valve, mixer,
fan and burner have no damage and are
properly fitted.
Front cover should be removed in order to
inspect
components
instructions below).
Plastic decals
Remove front cover
visually
(see
6 720 608 257
Advertisement
Table of Contents
