Maintenance - Hyundai HSDT55 Original Instructions Manual

Safety Instructions in your user manual, and all regulations for operation of the unit.
4. We recommend that a face mask be worn when operating the blower in dusty areas.
5. Stand away from the debris, at a distance that will easily allow you to control the direction of blown debris.
Never blow debris in direction of bystanders.
6. To control velocity of air stream, blower can be operated at any speed between idle and full throttle.
Experience with the unit will help you determine the amount of airflow necessary for each application.
7. To reduce sound levels, limit the number of pieces of equipment used at any one time.
8. Check your equipment before operation, especially the muffler, air intakes and air filters.
9. Use rakes and brooms to loosen debris before blowing. In dusty conditions, slightly dampen surfaces
when water is available.
10. Conserve water by using power blowers instead of hoses for many lawn and garden applications,
including areas such as gutters, screens, patios, grills, porches and gardens.
11. Use intermediate tube plus nozzle of your choice so the air stream can work close to the ground.
12. After using blowers and other equipment, CLEAN UP! Dispose of debris in trash receptacles.
Operating instructions
1. Follow the instructions "STARTING A COLD ENGINE".
2. Once unit is running, place unit on your back by slipping arms through the shoulder straps as if you were
putting on a backpack.
3. When preparing to clear an area of debris, always position yourself so that you can control the direction
debris will be blown.
4. The control handle and the flexibility of the blower tube assembly will allow you to clear the most hard-to-
reach areas.
5. The hand grip, throttle trigger, lock-out button and on/off ignition switch are all mounted on a swivel
handle that offers a wide range of operating positions and comfort.

MAINTENANCE

Cleaning the Air Filter
Dirty air filers reduce engine power increase fuel consumption and make starting more
difficult.
 Turn choke knob to
 Release the screws (1) and pull off the filter cover (2).
 Remove the filter from the cover and inspect it - if it is dirty or damaged, clean the filter or
fit a new one.
 Install the main filter and prefilter elements in the filter cover.
 Fit the cover on the filter base and tighten it down firmly.
WARNING: Before using your blower, review the
These precautions and regulations are for your protection.
11