Standard Mig/Mag Torch - EWM Taurus 355 Synergic S LP MM TKM Operating Instructions Manual

Example 1: Welding workpieces with different sheet metal thicknesses (non-latched)
Example 2: Welding different positions on a workpiece (latched)
Example 3: Aluminium welding of different sheet metal thicknesses (non-latched or latched
special)
Up to 16 programs (P
An operating point (wire speed, arc length correction, dynamics/choke effect) can be defined
permanently in each program.
Program P0 is an exception: the settings for operating points are made manually here.
Changes to the welding parameters are saved immediately!

5.3.12 Standard MIG/MAG torch

The MIG welding torch trigger is essentially used to start and stop the welding process.
Operating elements
Torch trigger
Additional functions such as program switching (before or after welding) are possible by tapping the torch
trigger (depending on machine type and control configuration).
The f ollowing parameters must be configured accordingly in the menu Special Parame-
ters > see 5.10 chapter .
• Switching between welding programs (P8).
• Program selection before welding start (P17).
• Switching between wire f eeders in dual operation (P10).
099-005421-EW501
13.12.2022
Figure 5-36
Figure 5-37
Figure 5-38
to P ) can be defined.
A0 A15
Functions
• Start/stop welding
Design and function
MIG/MAG welding
51