Cleaning & Replacing The Filters - Bissell ICONpet PRO 2746 Series Quick Start Manual

Cleaning & Replacing the Filters
Go to support.BISSELL.com for tips on maintaining and replacing your vacuum filters.
Pre-Motor Filters
For best cleaning performance, always clean your pre-motor filter after each use.
1.
To clean the pre-motor
filter, turn OFF machine and
remove Dirt Tank from the
hand vacuum.
Post-Motor Filter
1.
To clean your post-motor
filter, turn OFF machine and
press the latch on the back of
the hand vacuum.
WARNING
» Do not use your vacuum until you are familiar with all instructions and operating procedures.
» Before using your vacuum, make sure that the Dirt Tank is in locked position and that all filters, both pre and post-filters, are in
place. DO NOT operate your vacuum without these filters.
2.
Pull filter from the top of
the tank. Remove the filter
from the filter frame housing.
Tap the filter against the side
of a trash bin to remove dust
and debris.
2.
Remove the post-motor
filter from the vacuum.
3.
To clean, rinse under warm
water and squeeze to remove
dirt. Lay out for 24 hours, until
completely dry. Make sure
to replace your filter into the
frame with the tag side down
(touching the frame) before
using your machine.
3.
If there's debris on the filter,
tap it on a trash bin and rinse
under warm water. Let dry
for at least 24 hours before
putting it back in the vacuum
and replacing the filter cover.
BISSELL.com 9