Emptying The Dirt Tank; Removing The Brush Roll - Bissell ICONpet PRO 2746 Series Quick Start Manual

Emptying the Dirt Tank

More of a video person? Go to support.BISSELL.com for additional how-to videos.
1.
Turn OFF your machine.
Remove the Dirt Tank from the
hand vacuum by sliding the
latch on the front of the tank.
4.
Dump dirt from the tank
into the trash bin.
Removing and Changing the Brush Roll
Go to support.BISSELL.com for a full list of maintenance and troubleshooting support.
1.
Turn the machine OFF and
press the Foot Release Button
to disconnect the Motorized
Floor Cleaning Foot from the
Extension Wand.
WARNING
» Before using your vacuum, make sure that the Dirt Tank is in locked position and that all fi lters, both pre and post-fi lters, are in
place. DO NOT operate your vacuum without these fi lters.
8 BISSELL.com
2.
Grab the top of the tank
and pull up. This will activate a
wiping feature to remove debris
from the mesh filter screen.
5.
Slide the separator back
into the tank, ensuring the
notch is seated into the tank
correctly.
2.
With a flathead screwdriver
or coin, twist the slot on the
side of the foot clockwise and
pull the Brush Roll out.
3.
Fully remove the separator
from the tank and tap the
mesh screen on the side of the
trash bin.
2
1
6.
Put the whole tank into
the hand vacuum by guiding
the notched out area on the
bottom of the tank onto the
hook on the hand vacuum.
Push into place.
3.
To use the hard floor brush
roll or replace the brush after
cleaning it, push the brush roll
back in the chamber and twist
counter-clockwise with a tool
or coin to lock in place.