Cleaning And Replacing The Filters - Bissell CLEANVIEW ALLERGEN PET 2849 Quick Start Manual

Cleaning and Replacing the Filters

Visit BISSELL.ca to find replacement filters.
Pre-Motor Filter
1. 2.
Press the Dirt Tank Release Open the tank lid by lifting
Button and pull away from up.
vacuum.
4. 5.
Clean with mild detergent, Return Pre-Motor Filters
rinse and squeeze all excess to the top of the Dirt Tank.
water. Allow filters to dry Put the thin flat filter with the
completely before reinserting. white tab in first, then put the
thick foam filter in.
Post-Motor Filter
For optimal performance, replace the filter every 6 months.
1. 2.
Press down on tab to Press tab on right side of
remove Post-Motor Filter cover filter and pull out to remove
and pull away from vacuum. from vacuum. Remove debris
from filter by tapping on the
side of a trash container. This
pleated filter may NOT be
washed.
WARNING
To reduce the risk of electrical shock:
» Turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
» Do not operate vacuum with damp or wet fi lters. Allow components to dry before reassembling the Dirt Tank.
» Do not use without fi lters in place.
6 BISSELL.ca
3.
Remove Pre-Motor Filters
from top of Dirt Tank lid by
pulling out.
6.
You should hear a click
when tank lid is closed
securely.
3.
When reassembling, be
sure to lock the filter back into
place by aligning one side of
the filter first, then clicking the
other side into place.