6.4
Closing the burner
To close the burner proceed as follows:
push the burner until it is about 4" from the sleeve;
re-connect the leads.
Remove the extension bars 31)(Fig. 5, page 11).
Slide in the burner until it comes to a stop;
refit screws 3) and pull the leads gently out until they are
slightly stretched;
re-couple the swivel coupling 7) to the graduated sector;
reconnect the light-oil pipes.
Re-screw the 2 screws and the safety plate Fig. 12, page 18.
After carrying out maintenance, cleaning or check-
ing operations, reassemble the hood and all the
safety and protection devices of the burner.
20095062
Maintenance
38
GB