Table of Contents
Advertisement
KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the
various controls and adjustments. Save this manual for future reference.
Chain Adjustment
Front Hand Guard
Tool
(Bar Tool)
Chain
Bar Sprocket
Bar Oil
Hole
Fill Cap
Cylinder Cover
Throttle
Lock--out
Rear
Handle
Throttle
Trigger
Chain Brake
Choke/Fast
Idle Lever
ON/STOP SWITCH
The ON/STOP SWITCH is used to stop the
engine.
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed.
THROTTLE LOCK-- OUT
The THROTTLE LOCK--OUT must be
pressed before you can squeeze the throttle
trigger. This feature prevents you from acci-
dentally squeezing the trigger.
CHOKE/FAST IDLE LEVER
The choke and fast idle speed are set by pull-
ing the CHOKE/FAST IDLE LEVER out fully
for cold or for refueled starting. The choke
provides additional fuel to the engine during
cold starting.
OPERATION
Front Handle
Starter Rope
Muffler
Starter Housing
Adjusting
Screw
Chain Brake Nuts
CHAIN BRAKE
The CHAIN BRAKE is a device designed to
stop the chain if kickback occurs. The chain
brake activates automatically in the event of
kickback. The chain brake activates manu-
ally if the front hand guard is pushed forward.
The chain brake is disengaged by pulling the
front hand guard back toward the front han-
dle as far as possible.
CHAIN TENSION
It is normal for a new chain to stretch during
first 30 minutes of operation. You should
check your chain tension frequently. See
CHAIN TENSION in the ASSEMBLY sec-
tion.
WARNING:
ing and after use. Do not touch the muffler or
allow combustible material such as dry
grass or fuel to do so.
8
ON/STOP
Switch
Fuel Mix Fill Cap
Direction
of Chain
Travel
Guide Bar
Muffler is very hot dur-
Advertisement
Table of Contents
