Table of Contents
Advertisement
5)
OPERATION
1. The controls that operate the belt conveyor speed and the heaters are located on the front of the unit.
2. The On/Off switch is used to turn the unit on or off. Once the unit is turned on the conveyor will automatically
run. Warning: Ensure no hands, tools or parts are located on the conveyor as injury will result when unit is
turned on.
3. Note: Before moving the On / Off switch to the "On" position, please read the following statements:
4. A. CAUTION! HOT SURFACES! The exterior metal surfaces of the unit will get hot enough to cause burns.
Avoid touching these surfaces to prevent injury.
B. WARNING! SEVERE BURN HAZARD QUARTZ HEATERS. The quartz heaters or metal heaters
located in the top of the unit operate at very high temperatures. DO NOT TOUCH HEATERS AFTER
UNIT IS TURNED ON.
5. This oven has 2 heating zones, 1 above the conveyor, and one beneath the conveyor.
Operation Instructions for 350E and 500E "Toast on Demand Mode"
1. Turn the power switch located in the back of the unit to the on position.
2. Press the "PWR" button located on the control panel on the front of the unit.
3. The display will display a "-" then the word "HEAT." When the unit has completed its heat up
cycle it will display "IdLE."
4. After the display shows "IdLE" the unit is ready to use.
5. Press the desired product button and place corresponding product on the wire rack so that it
touches the conveyor and may be conveyed into the toasting cavity.
6. Pressing the "DARKER" button will produce a darker toasted product.
7. Pressing the "LIGHTER" button will produce a lighter toasted product.
a. NOTE: the "DARKER" or "LIGHTER" button must be pressed immediately after product
button has been selected.
8. If the product is still not toasted enough or too much you can change the product key's
parameters. "See Product Key Programming".
9. Pressing the product key ("TOAST", "MUFFIN","BAGEL") multiple times will increase the on
time.
10. Pressing the "E-SAVE" button will cancel any product button command and return to the energy
saver or "IdLE" mode.
11. If "E-SAVE" is not pressed the toaster will automatically go to the "IdLE" mode after the
completion of product cycle.
12. To shut the unit off press and hold the "PWR" button for 10 seconds the display will display
"CooL." Wait until the display is blank, then shut off the unit with the power button located on the
back panel. Do not shut off until the display is blank or improper cooling will result, and may
affect the life of the product.
Operation Instructions for 350E and 500E "Continuous or Full-On Mode"
1. Turn the power switch located in the back of the unit to the on position, (if unit is in the "OFF"
position). If Unit is already "ON" skip to step 5.
2. Press the "PWR" button located on the control panel on the front of the unit.
5
Advertisement
Table of Contents
