Table of Contents
Advertisement
3. The display will display a "-"then the word "HEAT" when the unit has completed its heat up
cycle it will display "IdLE."
4. After the display shows "IdLE" the unit is ready to use.
5. Press the "OTHER" Button located at the right side of the control panel.
6. The display will display "heat" (In early versions the display will show "pset" during this heat up
cycle)
7. The unit will heat up to the user defined preset temperature "factory default is 500 F". To set
preset temperature see "Product Key Programming".
8. The display will display "redy" and then show the countdown of time remaining in this
continuously on mode.
9. When timer countdown has begun, product can be placed at any time on the wire rack to be
conveyed into the toasting cavity.
10. Pressing the "LIGHTER" button will speed the conveyor up to achieve a lighter toasted product.
11. Pressing the "DARKER" button will slow the conveyor down to achieve a darker toasted
product.
12. Pressing the "E-SAVE" at any time during the continuous on mode will cancel any product
button command and return to the energy saver or "IdLE" mode.
13. If "E-SAVE" is not pressed the toaster will automatically go to the "IdLE" mode after the
completion of program time cycle. (To change the time cycle see "Product Key Programming)
(Factory Default is 2:00 hours).
14. To shut the unit off press and hold the "PWR" button for 10 seconds the display will display
"CooL." Wait until the display is blank, then shut off the unit with the power button located on the
back panel. Do not shut off until the display is blank or improper cooling will result, and may
affect the life of the product.
Operation Instructions for 350L and 500L
1. Turn the Power Switch on located on the front of the unit. When the unit is "ON", the conveyor
belt will move.
2. Turn the timer to the desired time frame. There are 3 settings for using the timer
a. "OFF" – This removes the timer from the circuit and allows the conveyor and heating
elements to run as set in full-on mode.
b. "e-SAVE" – The green indicator light is on when this mode is active. The heating elements
are running at quarter power to keep the toaster prepared for shorter startup times, but
saving energy compared to a full-on run.
c. "TIMER" mode – The Amber indicator light is on when this mode is active. The timer allows
the toaster to run full-on until timed out, when it then switches to the e-SAVE mode.
3. Use the "TOP HEAT" and "BOTTOM HEAT" knobs to adjust to the desired temperature and
achieve the toasting pattern. Knobs can be turned to an "OFF" position, turning off the heat in a
full run mode. In "E-SAVE" mode, the elements (even if "OFF") will cycle to keep cavity
temperature up.
4. Use the conveyor speed control to get the desired toast quality – "DARK" will run the conveyor
slower and "LIGHT" will run the conveyor faster.
6
Advertisement
Table of Contents
