3. Align the knob set screw with the flat on the side of the control
shaft.
Control flat
4. Re-attach the knob using the hex key.
5. Repeat for all four controls requiring adjustment.
6. Install your camera and check all controls. On the surface you
may need to apply pressure to the control while rotating for proper
operation.
7. Store the extra washers with your spare parts.
Re-Adjusting Controls for E-M10 Mark IV
This procedure is reversible. To use the E-M10 Mark IV after adjusting
for the E-M10 Mark III, use the same procedure to re-install one
washer underneath each of the four control knobs.
Washer
Set screw
11