Attaching A Fiber Optic Cord - Ikelite 69531 Manual

Changes in the E-M10 Mark IV flash height prevent it from
»
extending far enough to fire while the camera is installed in the
housing. A compatible bulkhead, hotshoe, electric sync cord,
and strobe with electronic bulkhead are required for external
flash triggering with the newer Olympus OM-D E-M10 Mark IV
camera.
To connect two strobes to the housing, you must use two fiber
»
optic cords.

Attaching a Fiber Optic Cord

1. Check the end of the fiber optic cord to ensure that it is clean and
smooth.
2. Check that the fiber optic cord o-ring is in place. This o-ring does
not provide waterproofing, but it does keep the fiber optic cord in
place.
3. Attach one end of the fiber optic cord to one of the fiber optic ports
on the housing. The connector is a press-fit into the port.
4. Attach the other end of the fiber optic cord to a compatible strobe.
5. Set the strobe according to the manufacturer recommendations.
6. Turn on the strobe.
7. Turn on the camera. Take a test photo to ensure that your strobe(s)
are functioning properly
18