Re-Adjusting The Control For Zs80, Tz95; Setting Up Your Housing; Opening The Housing - Ikelite 6170.70 Instruction Manual

4. Re-attach the knob using the hex key.
5. Install your camera and check all controls. On the surface you
may need to apply pressure to the control while rotating for proper
operation.
6. Store the extra washer with your spare parts.

Re-Adjusting the Control for ZS80, TZ95

This procedure is reversible. To use ZS80 or TZ95 cameras, use the
same procedure to re-install one washer underneath the control knob
for the mode dial.

Setting Up Your Housing

Opening the Housing

1. Push the lid snap lock forward and lift the curved end away from
the housing.
2. Lid snaps are designed to provide enough force to compress the
o-ring for a proper seal. Keep firm pressure against the lid snap
while lifting it away.
3. Repeat with opposite lid snap.
4. Remove the housing back.
Lock
11