Table of Contents
Advertisement
en Basic operation
Cleaning the door pane
Note: To ensure tightness, the door seal is lubricated
at the factory. Residue may remain on the door pane.
Before using for the first time, clean the door pane
▶
with glass cleaner and a window cloth or a mi-
crofibre cloth.
Do not use a glass scraper.
Cleaning accessories
Before first use, clean the accessories thoroughly
▶
using hot soapy water and a soft cloth.
7 Basic operation
7.1 Activating the appliance
To exit standby mode, open the door and turn the
1.
function selector or touch a touch field.
Set the required function.
2.
7.2 Opening the appliance door
Press
.
1.
a The appliance opens the appliance door.
Use the recessed grip on the side of the oven to
2.
open the appliance door fully.
If the childproof lock is activated, press and hold
for a few seconds until the appliance opens the
door.
7.3 Fill the water tank
WARNING ‒ Risk of fire!
Due to the hot surfaces, vapours from flammable li-
quids may catch fire in the cooking compartment and
cause an explosion. The appliance door may spring
open. Hot steam and jets of flame may escape.
Only fill the water tank with water or with the descal-
▶
ing solution that is recommended by us.
WARNING ‒ Risk of burns!
The front edge of the cooking compartment becomes
very hot during operation.
When removing the water tank, only touch its
▶
handle.
ATTENTION!
The use of unsuitable liquids may damage the appli-
ance.
Only use fresh tap water, softened water or uncar-
▶
bonated mineral water.
If the tap water is very hard, we recommend using
▶
softened water.
Do not use distilled water, highly chlorinated tap wa-
▶
ter (above 40 mg/l) or other liquids.
Note: Fill the fresh-water tank → Page 7 before operat-
ing the appliance with steam.
To cook without steam, leave the empty water tank in
the tank slot in the appliance.
The fresh-water tank is on the right-hand side of the ap-
pliance. The fresh-water tank has a capacity of approx.
1.7 litres.
Open the appliance door.
1.
14
Heating up the appliance
Ensure that there is no leftover packaging in the
1.
cooking compartment.
Remove any accessories from the cooking compart-
2.
ment.
To eliminate the new-appliance smell, heat up the
3.
empty appliance with the door closed.
The ideal setting for heating is and 200 °C for
one hour.
Pull the fresh-water tank out of the appliance until
2.
the fill level indicator is visible, or completely re-
move the fresh-water tank from the appliance.
Open the valve on the fresh-water tank.
3.
Fill the fresh-water tank with cold water up to the
4.
"Max." mark.
Close the valve on the fresh-water tank.
5.
Slide the fresh-water tank back in as far as it will go.
6.
When fitting the tank lid and sliding the tank in, ob-
7.
serve the symbols for fresh water and process water
→ Page 7.
7.4 Switching on the appliance
Use the function selector to set the required type of
1.
heating.
a The display shows the selected type of heating and
the suggested temperature.
If required, use the rotary selector to set the desired
2.
temperature.
a The display shows the heating symbol
a The bar displays the current heating status.
.
Advertisement
Table of Contents
