Toshiba RAS-M05G3KVSG-E Service Manual page 39

FIREPLACE OPERATION
Keep indoor unit's fan blowing continuously during thermo off, to circulate
heat from other sources over the room. There are three setting parameters:
Default setting > Fireplace 1 > Fireplace 2
Fireplace 1:
● During thermo off period, the indoor unit's fan will continue to run by the
same speed, previously selected by end-user.
Fireplace 2:
● During thermo off period, the indoor unit's fan will continue to run at
super-low speed, programmed from factory.
Fireplace Operation Setting
1. Press MENU button for enter menu setting and press TEMP. button to
select FIREPLACE
°C
2. Enter FIREPLACE set by press MENU button.
triangle mark will stop blink and setting feature will be blink instead.
°C
3. Select FIREPLACE operation by press TEMP. button
°C
FIREPLACE 1 FIREPLACE 2
4. Confi rm selected feature by press MENU button again.
°C
When feature had selected will return to menu selection display triangle
mark will blink .
5. Leave from menu setting display by select EXIT.
°C
Note:
● While Fireplace operation on heating mode, indoor unit fan always runs and
cold air breezing might be occurred.
● Fireplace will operate in Heating mode only.
Blink both triangle and
feature mark Feature
not yet set
None
Blink only triangle
Feature already set
TIMER OFF OPERATION
To set the timer OFF when the air conditioner is operating.
1. Press MENU button for enter menu setting and press TEMP. button to
select TIMER OFF.
2. Enter TIMER set by press MENU button.
triangle mark will stop blink and setting feature will be blink instead.
3. Select TIMER OFF by press TEMP. button.
Can select TIMER OFF from 0.5 - 12hrs.
4. Confi rm TIMER OFF by press MENU button.
5. Leave from menu setting display by select EXIT.
Note:
● Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
● The setting will be saved for the next same operation.
Cancel TIMER OFF
6. During TIMER OFF already set (no.5) press MENU button and press
TEMP. button to select TIMER OFF.
7. Press MENU button again will cancel TIMER OFF.
8. Leave from menu setting display by select EXIT.
- 39 -
Blink both triangle and
feature mark Feature
not yet set
Blink only triangle
Feature already set
Blink only triangle
Feature already set
Blink both triangle and
feature mark Feature
not yet set