Hitachi C12RSH2S Safety Instructions And Instruction Manual page 36

English
(4) Lift the lower guard and mount the saw blade.
WARNING:
(5) Thoroughly clean washer (B) and the 10 mm bolt, and install them onto the saw blade
spindle.
(6) Press in the spindle lock and tighten the 10 mm bolt by turning it to the left by 17 mm
wrench (Standard accessorie) as indicated in Fig. 51-c.
CAUTION:
2. Dismounting the saw blade
Dismount the saw blade by reversing the mounting procedures described in paragraph
1 above.
The saw blade can easily be removed after lifting the lower guard.
CAUTION:
NOTE
: After using the 17mm wrench, store it in your tool box not to lose it.
TRANSPORTATION OF THE MAIN BODY
The vice assembly could be dropped during transportation.
Either remove the assembly or slip a piece of wood between
the vice to fi rmly secure it.
Drop the head and insert the locking pin (see P.13 "Releasing
the locking pin").
Also screw in the slide securing knob so that the hinge is
positioned to hit the holder (A) and secure the head.
36
When mounting the saw blade, confi rm that the rotation indicator
mark on the saw blade and the rotation direction of the spindle
cover (see Fig. 1) are properly matched.
* A dust guide is installed inside behind the hinge.
When removing or installing the saw blade, do not make contact
with the dust guide. Contact may break or chip saw blade tips.
* Confi rm that the spindle lock has returned to the retract position
after installing or removing the saw blade.
* Tighten the 10 mm bolt so it does not come loose during
operation.
Confi rm the 10 mm bolt has been properly tightened before the
power tool is started.
Never attempt to install saw blades larger than 12" (305 mm) in
diameter.
Always install saw blades that are 11-9/16" (293 mm) to 12" (305 mm).
Slide Securing Knob
Holder (A)
Hinge
Fig. 52-a