Table of Contents
Advertisement
d. Release of a jammed saw
If the saw gets stuck during cutting, the operators should:
Saw the saw and attach it securely to the cutting foot of the shaft (ie trunk side)
-
or has a separate chord from the tool
Pull the saw of the cluster while the branch is lifted, if necessary,
-
If necessary, use a hand saw or a second chainsaw to release the chain saw.
-
4. Cutting work
The tool should only be used to cut trees. Do not use it for other applications.
Do not attempt to remove the chainsaw when it is stuck during operation. Stop the
machine and remove the wedge blade with a wedge.
Stick your feet well, keep a good balance and do not climb on the tree trunk.
Try not to work on a slope. However, if you have to work on a slope, always stand higher
than the tree trunk.
Before bending a branch or trunk in bending, observe the direction of bending and finish
the cut opposite the bending side to prevent the chain guide from getting stuck in the cut.
a. Felling of trees
Examine the work area and estimate where the tree will fall. Start the machine as
described above. Start by making a notch in the direction of fall chosen.
When the tree falls, shout or make a beep to alert people in the vicinity. When the
shaft falls, move away from the cutting area.
b. Trunk on the ground
Cut half of the trunk, turn it over and finish the cut on the other side.
c. Trunk in elevation
Begin by cutting a first part from below and then from above. Then, on the second part,
repeat this operation.
14
Advertisement
Table of Contents
