Advertisement
3. Carefully rotate the Console Base (45) to the posi-
tion shown. Secure the Console Base with two
Console Base Bolts (91), two Console Base
Washers (90), and two Console Base Nuts (11) as
shown.
Refer to the inset drawing. Tighten all four
Console Base Bolts (91) and Console Base Nuts
(11) as tightly as possible. Carefully lift up and
push down on the handrails to make sure that
the Console Base (45) does not move. Regularly
inspect and tighten all four Console Base Bolts
and Console Base Nuts.
4. Attach the Frame Guide (66) and the Frame Guide
Spacer (46) to the left side of the Frame (21) with
two Guide Screws (25). Note: Be careful not to over-
tighten the Guide Screws. Make sure that the thick
end of the Frame Guide is at the bottom.
5. Remove the backing from the Adhesive Clip (2).
Press the Adhesive Clip onto the base of the Upright
(37) in the indicated location. Press the Allen
Wrench (35) into the Adhesive Clip.
6. The Console (49) requires two "AA" batteries (not
included); alkaline batteries are recommended.
Open the Battery Cover (48) as shown. Press two
batteries into the battery compartment, with the neg-
ative ends of the batteries (marked ÒÐÓ) touching the
springs. Close the Battery Cover.
7. Make sure that all parts are properly tightened
before you use the treadmill. To protect the floor or
carpet from damage, place a mat under the
treadmill.
3
90
11
Handrails
11
4
25
66
Thick end
5
6
Batteries
6
45
91
91
45
91
91
46
21
37
2
35
49
48
90
11
11
Advertisement
