Advertisement
DIAGRAM OF THE CONSOLE
Speed Control
CAUTION:
console, read the following precautions.
¥ Do not stand on the walking belt when turning
on the power.
¥ Always wear the clip (see the drawing above)
whilst using the treadmill. When the key is
BATTERY INSTALLATION
The console
requires three
"AA" batteries
(not included).
Alkaline batteries
are recommended.
To install batteries,
open the battery
cover under the
console. Press
three batteries into
the battery compartment. Make sure that the negative
ends of the batteries (marked ÒÐÓ) are touching the
springs. Close the battery cover.
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.)
Clip
Before operating the
Batteries
Battery
Cover
On/Reset
Button
Key
removed from the console, the walking belt
will stop.
¥ Adjust the speed in small increments.
¥ To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids on
the console. Use only a sealable water bottle.
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothing.
Follow the steps below and on page 9 to operate the
console.
Insert the key fully into the power switch.
1
Note: Inserting the key
will not turn on the dis-
plays. The displays will
turn on when the
On/Reset button is
pressed or when the
walking belt is started.
If you just installed
batteries, the displays
will already be on.
8
Displays
Thumb Pulse
Sensor
Advertisement
