Advertisement
WORK
Removing the seat
3.1
Mounting the seat
3.2
Installing the front wheel
3.3
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Remove screw
–
Lift up the seat at the rear, pull it back and then remove it from above.
500080-10
–
Hook in the front of the seat at the collar sleeve of the fuel tank, lower it at the rear
and simultaneously push it forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixing.
Guideline
Remaining screws, chassis
600674-01
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease shaft seal rings
Long-life grease (
–
Insert the spacers.
500086-11
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Activate the hand brake lever multiple times until the brake linings are in contact
with the brake disc.
–
Remove the motorcycle from the lift stand.
500084-11
–
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
–
Fully tighten screw
Guideline
Screw, fork stub
.
M6
and bearing surface
p. 14)
.
M24x1.5
.
M8
7
10 Nm (7.4 lbf ft)
of the spacers.
45 Nm
(33.2 lbf ft)
15 Nm
(11.1 lbf ft)
Advertisement
