Room Cooling And Humidifying - Honeywell CL20AE User Manual

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
MODE (COOL)
Press the MODE button to select COOL mode. Pressing the MODE button until COOL is illuminated
on the control panel activates evaporative cooling. The water pump will operate and you will feel the
cooler air after the Honeycomb Cooling Media is completely wet.
Pressing the MODE button again will deactivate COOL light on the control panel, switching off
evaporative cooling.
Note:
When the cooling function is switched OFF, the unit can still function in a fan only mode (without
evaporative cooling).

ROOM COOLING AND HUMIDIFYING

In cooling mode, Honeywell Air Coolers provide moisturized air through
Water Regulator
the evaporation of water. There is a manual Water Regulator knob located
in the ice compartment of the unit. This allows you to adjust the amount
of water pumped over the Honeycomb Cooling Media, thus helping to
control cooling and humidification levels.
MIN
When the Water Regulator is set to MIN, the water pump distributes a
minimal amount of water to the Honeycomb Cooling Media. This results
MAX
in less water evaporation and reduces the cooling effect.
When the Water Regulator is set to MAX, the water pump distributes the maximum amount of water
to the Honeycomb Cooling Media. This results in maximum water evaporation and the cooling
performance improves.
EN 3