Room Cooling And Humidifying; Remote Control - Honeywell CO70PE User Manual

USE & OPERATION (CONTINUED)

ROOM COOLING AND HUMIDIFYING

In cooling mode, Honeywell Air Coolers provide cool, moist air through the
evaporation of water. There is a manual Water Regulator knob located behind
the ice compartment of the unit. This allows you to adjust the amount of water
pumped over the Honeycomb Cooling Media, thus helping to control cooling
and humidification levels.
When the Water Regulator is set to MIN, the water pump distributes a minimal
amount of water to the Honeycomb Cooling Media. This results in less water
evaporation and reduces the cooling effect.
When the Water Regulator is set to MAX, the water pump distributes the maximum amount of water
to the Honeycomb Cooling Media. This results in maximum water evaporation and greater cooling
performance.

REMOTE CONTROL

ON/OFF
SWING (H)
TIMER MODE
SPEED
NOTE:
• The remote control requires AAA (2 x 1.5V) batteries for replacement.
• Open the battery compartment at the back of the remote control and insert the batteries inside.
Care must be taken to insert the batteries according to the correct polarity (+ / –) markings
shown inside the battery compartment.
• Always point the remote control signal transmitter towards the unit when operating. Make sure
that the signal path is not obstructed.
• Remove the batteries if the unit is not going to be used for an extended period of time.
• Do not drop the remote control.
• Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
• Do not mix old and new batteries.
• Do not recharge the battery.
POWER : ON / OFF
SWING : Controls the motion of the horizontal louvers
TIMER : Controls the Timer function for automatic off
MODE : Controls the motion of the vertical louvers and
evaporative Cooling On / Off
SPEED : Controls timer function for automatic off
EN 4
Water Regulator
MAX
MIN