Advertisement
Table of Contents
USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
MODE (COOL)
Press the MODE button to select COOL mode. Pressing the MODE button until COOL is illuminated
on the control panel activates evaporative cooling. The water pump will operate and you will feel the
cooler air after the Honeycomb Cooling Media is completely wet.
Pressing the MODE button again will deactivate COOL light on the control panel, switching off both
evaporative cooling function altogether.
Note: When the cooling function is switched OFF, the unit can still function in a fan only mode
(without evaporative cooling).
ROOM COOLING AND HUMIDIFYING
In cooling mode, Honeywell Air Coolers provide cool, moist air through the evaporation of water.
There is a manual Water Regulator knob located in the ice compartment of the unit. This allows you
to adjust the amount of water pumped over the Honeycomb Cooling Media, thus helping to control
cooling and humidification levels.
When the Water Regulator is set to MIN, the water pump distributes a
Water Regulator
minimal amount of water to the Honeycomb Cooling Media. This
results in less water evaporation and reduces the cooling effect.
When the Water Regulator is set to MAX, the water pump distributes
MIN
the maximum amount of water to the Honeycomb Cooling Media. This
results in maximum water evaporation and the cooling performance
improves.
MAX
EN
3
Advertisement
Table of Contents
