Room Cooling And Humidifying; Remote Control - Honeywell CL30XC User Manual

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
WARNING: Please ensure sufficient water is in the water tank otherwise you may hear a Low Water
Alarm and the cooler will start in a Fan only mode without evaporative cooling.
TIMER
Press the TIMER button until the desired time duration setting is selected. When the set time has
passed, the unit will automatically turn off (unit remains in Standby mode until power cord is unplugged
from electrical socket). The TIMER function allows you to program the unit for up to 8 hours of use.
SWING or SWING / IONIZER*
Press the SWING or SWING / IONIZER* button until
the display screen. The louvers will begin to move left to right automatically.
Vertical Air Flow - You can manually adjust the louvers to change vertical air flow.
An Ionizer helps to reduce particles in the air, thus promoting cleaner air quality. For models with Ionizer,
Press the SWING / IONIZER* button until
and Ionizer can be activated simultaneously when both lights are illuminated together.
SLEEP
Press the SLEEP button until
selected, the fan will run on High for one hour, then Medium for the second hour and on Low speed
from the third hour onwards until you switch off the unit.

ROOM COOLING AND HUMIDIFYING

In cooling mode, Honeywell Air Coolers provide cool, moist air through the
evaporation of water. There is a manual Water Regulator knob located in
the ice compartment of the unit. This allows you to adjust the amount of
water pumped over the Honeycomb Cooling Media, thus helping to control
cooling and humidification levels.
When the Water Regulator is set to MIN, the water pump distributes a
minimal amount of water to the Honeycomb Cooling Media. This results in
less water evaporation and reduces the cooling effect.
When the Water Regulator is set to MAX, the water pump distributes the maximum amount of water to
the Honeycomb Cooling Media. This results in maximum water evaporation and greater cooling
performance.

REMOTE CONTROL

Model with Ionizer Model without Ionizer
POWER
SWING
SPEED SPEED
IONIZER
TIMER
COOL SLEEP COOL
Note:
• The remote control requires AAA (2 x 1.5V) batteries for replacement.
• Open the battery compartment at the back of the remote control and insert the AAA (2 x 1.5V)
batteries inside. Care must be taken to insert the batteries according to the correct polarity (+ / –)
markings shown inside the battery compartment.
• Always point the remote control signal transmitter towards the unit when operating. Make sure that
the signal path is not obstructed.
• Remove the batteries if the unit is not going to be used for an extended period of time.
• Do not drop the remote control.
2
is illuminated on the display screen. When the SLEEP mode is
POWER
POWER
SPEED
COOL
SWING
TIMER
SWING / IONIZER*
SLEEP
TIMER
SLEEP
is illuminated on
is illuminated to activate the Ionizer function. Both Swing
*Applicable for models with Ionizer feature only.
: ON / OFF
: Low / Medium / High
: Evaporative Cooling On/Off
: Controls the motion of the louvers and Ionizer*
function
: Controls the Timer function for automatic shut off
: Turns on Sleep mode
*Applicable for models with Ionizer feature only.
LOUVER MOVEMENT
Water Regulator
MIN
MAX