Table of Contents
Advertisement
HOW TO START THE PYROLYSIS CYCLE
Important: the pyrolysis cycle must only be performed with the oven empty; so,
before starting the cycle take all the accessories (shelves, baking/grill tray and anti-
grease filter) out of the oven cavity and dry any traces of overflowed liquid.
3
2
Do not use any degreasing products (e.g. degreasing
sprays, detergents, etc.).
1.
Close the oven door (if it is open or not closed
properly the pyrolysis cycle will not start).
2.
Turn the oven selector knob to the pyrolysis
position (P); P0•00 appears on the electronic
programmer display with the letter P flashing.
3.
Press pushbutton 3 on the programmer to start
the cycle.
This combined confirmation operation offers greater
safety when there are children; in fact turning the
knob to the pyrolysis function has no effect if key 3
of the programmer is not then pressed.
■ P1•30 (pyrolysis time, 1 hour and 30 minutes)
■ On the control panel the pilot light with the key
4.
To increase the pyrolysis cycle time (max 3 hours)
press key 2 of the programmer then key 6. To go
backwards to the minimum of 1 hour and 30 minutes
press key 2 then key 5.
■ During the setting AUTO flashes and P
5.
The pyrolysis cycle starts immediately and is
completed in the programmed time.
■ Throughout the pyrolysis cycle the programmer
5
6
VERY IMPORTANT:
The pyrolysis only starts with the oven door closed.
If the door is open or not closed properly the oven
CANNOT perform the pyrolysis; electronic safety
devices prevent the pyrolysis from starting.
appears and the door is locked.
lights up to indicate that the door is locked.
disappears.
displays the time (hours and minutes) remaining
until the cycle is finished.
25
Advertisement
Table of Contents
