Table of Contents
Advertisement
PROGRAMMER
MESSAGE
I I I I
I I I I I I
I I I I
I I I I I I
MESSAGE MEANING
door.
The oven function selector
knob has been turned to the
pyrolysis function with the oven
door open.
door
flashing and audible signal.
The function selector knob has
been turned to the pyrolysis
function for 5 minutes with the
oven door open.
door
AUTO
with
flashing. The
oven door has been opened with
the Pyrolysis cycle in progress.
The Pyrolysis cycle cancels.
door
AUTO
with
flashing and
audible signal. The oven door has
been opened for 5 minutes with
the Pyrolysis cycle in progress.
The Pyrolysis cycle is cancelled.
F0.00
AUTO
with
Temperature sensor measurement
error during the Pyrolysis cycle.
This may be due to the Pyrolysis
cycle being stopped and started
again when it was quite a way
through.
30
F0
30
F1
or
temperature sensor broken or not
working properly. The cooling fan
stays on in every cooking function
and if the pyrolysis cycle is in
progress the door stays locked.
30 F0
30 F1
or
.
30' countdown.
If the selector knob is turned and
then returned to 0 the count starts
again from 30.
Programmer with display off.
WHAT TO DO
Close the oven door and repeat
the
operations
Pyrolysis cycle.
Close the oven door, press any
programmer key to switch off the
audible signal and repeat the
operations to start the Pyrolysis
cycle.
Close the oven door and repeat
the
operations
Pyrolysis cycle.
Close the oven door, press any
programmer key to switch off the
audible signal and repeat the
operations to start the Pyrolysis
cycle.
Turn the oven selector knob to 0.
flashing.
Wait for at least 15 minutes
before repeating the operations to
start the Pyrolysis cycle.
If the message is still given after
several attempts call the After-
Sales Service.
.
Oven
Turn the function selector knob to
0
. The 30 minute countdown will
start (see below).
Wait for the countdown to stop.
The fan stops and the door, if
locked, unlocks.
Unplug the oven and contact the
After-Sales Service because the
oven can no longer be used.
Turn the function selector knob to
0
, wait for the oven to cool down
completely, switch the electricity
off for a few seconds.
If after this procedure the display
is still off unplug the oven and
contact the After-Sales Service.
The oven must not be used.
to
start
the
to
start
the
Advertisement
Table of Contents
