Table of Contents
Advertisement
PROGRAMMER
MESSAGE
variable
I I
MESSAGE MEANING
Cooking
time
set
temperature measured by the
internal sensor.
A temperature below 50°C has
been set.
The oven has switched off.
The audible signal has switched
off after the end of cooking (End).
dEF
= defrost
The
"defrosting
frozen
function has been set.
End
AUTO
with
flashing and
audible signal.
End of the programmed cooking.
00.00
with bell symbol flashing
and audible signal. End of the
timer countdown.
Start of the Pyrolysis cycle.
P0.00
P
with
flashing.
This
appears
after
because the function selector
knob has been moved from the
Pyrolysis function to a cooking
function. The temperature has
dropped below 300°C. The key
LED goes out and the door
unlocks.
P0.00
P
with
flashing. The oven
selector knob has been moved to
the Pyrolysis function (
P0.00
AUTO
with
End of the pyrolysis cycle. This
message remains until the door
unlocks.
WHAT TO DO
To
change
or
oven
temperature press key 4 of the
programmer,
then keys 5 or 6.
Press key 4 of the programmer,
then keys 5 or 6.
Turn the function selector knob to
0
. The time will appear.
To turn the oven off turn the
food"
function selector knob to
Press any programmer key to
silence the audible signal
appears (see specific note).
Turn the function selector knob to
Press any programmer key to
silence the audible signal.
The time appears.
To increase the cycle length, up to
max 3 hours, press key 2 of the
programmer then key 6. To reduce
to the minimum 1 hour 30 minutes
press key 2 of the programmer
and then key 5.
do.Lo
,
Turn the oven selector knob to
and repeat the operations to start
the Pyrolysis cycle.
To start the Pyrolysis cycle press
key 3 of the programmer.
To cancel the operation turn the
P
).
oven function selector knob to
flashing.
Wait for the door to unlock.
the
cooking
0
.
OFF
0
.
0
0
.
Advertisement
Table of Contents
