■Indicators and buttons
A
INITIAL SET button
(Initializing button)
SD slot cover
A
INITIAL SET button (Initializing button)
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera. When using a PoE hub, disconnect the Ethernet cable from
the camera. When using an external power supply, disconnect the 2P power cable (accessory)
from the 12 V DC power supply terminal.
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds. In about 2 minutes later, the camera will
start up and the settings including the network settings will be initialized. Retry if the camera
does not start up normally.
IMPORTANT:
When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
<Inside view of the SD memory card slot cover
SD memory
card slot
B
* This illustration represents WV-S4550L
(with SD memory card slot cover opened)>
ACT indicator
LINK indicator
C
DSD ERROR/ABF indicator
SD ERROR indicator
G
SD memory card warning/error indicator
Dome cover
*Do not directly touch the dome cover
surface with your hands.
19
F
SD ON/OFF button
E
SD MOUNT indicator
X4571L
X4571LM
S4550L
S4550LM