Directed Electronics 7900 Installation Manual page 20

Hide thumbs Also See for 7900:

Table of Contents

H1/8 GREEN (-) door trigger input, zone 3

Most vehicles use negative door trigger circuits. Connect the green wire to a wire which shows ground when any

door is opened. In vehicles with factory delays on the domelight circuit, there is usually a wire that is unaffected

by the delay circuitry. This wire will report Zone 3.

H1/9 BLACK/WHITE (-) 200 mA domelight supervision output

Connect this wire to the optional domelight supervision relay as shown below:

IMPORTANT! This output is only intended to drive a relay. It cannot be connected directly to the

domelight circuit, as the output cannot support the current draw of one or more light bulbs.

H1/10 WHITE/BLUE remote start (-) activation input

This input comes from the factory set to 2 activation pulses. This means that it is necessary to have 2 consecu-

tive ground pulses on the white/blue wire for the remote start to activate or to deactivate. The same holds true

for the remote control activation when set to a two pulse setting it is necessary to press the

for the remote start to activate or deactivate.

NOTE: The number of activation inputs can be programmed to 1 or 2 pulses. This setting affects

both the input wire and the remote control when operating the remote starter.

DRAFT

button twice

Table of Contents

Troubleshooting