Lenovo 7X12 Reference Manual page 28

• FQXSPBR4008I: Management Controller [arg1]: Configuration restoration from a file by user [arg2]
failed to start.
This message is for the use case where a user restores a Management Controller configuration from a file
and the restoration fails to start.
Severity: Error
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0138
User Action:
Complete the following steps until the problem is solved:
1. Turn off the server and disconnect it from the power source. You must disconnect the server from AC
power cycle to reset the XCC.
2. After 45 seconds, reconnect the server to the power source and turn on the server.
3. Retry the operation.
• FQXSPBT0007I: No bootable media available for system [ComputerSystemElementName].
This message is for the use case when an implementation has detected a System with No Bootable
Media.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: PLAT CIM ID: 0286
User Action:
Please ensure bootable media be installed correctly.
• FQXSPCA0002M: Numeric sensor [NumericSensorElementName] going low (lower critical) has
asserted.
This message is for the use case when an implementation has detected a Lower Critical sensor going low
has asserted.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Fan Failure
SNMP Trap ID: 11
CIM Prefix: PLAT CIM ID: 0480
User Action:
Complete the following steps:
1. Check the event log of XClarity Controller for any fan or cooling-related issues or power-related
issues.
2. Make sure that the airflow at the front and rear of the chassis is not obstructed and that fillers are in
place,clean, and correctly installed.
3. Make sure that the room temperature is within operating specifications.
24
ThinkSystem SR950 Messages and Codes Reference