Omron NV3W Connection Manual page 22

Company
MicroLogix
*1
Allen-Bradley
SLC-500 Series
Models that support
DF protocol
*1 S7-200 Series
Siemens
*1 MASTER-K Series
LG
*2 Models that support
Modbus
RTU protocol
*1 There may be restrictions in the device types and addresses that can be used for PLCs
*2 It is not possible to specify all PLC models that can be used. Test operation using the
Connection Diagrams
The connection diagrams between PLCs and NV-series PTs are based on the NV3W(-V1)
with 24-VDC input power. The connector on other NV-series PTs must be changed as
described below for other models of NV-series PTs.
NV3W with 5-VDC Input Power
Pin 3 changes from FG to NC. Do not connect anything to pin 3.
When connecting the PT to a non-OMRON PLC, use an external 5-VDC power supply.
You must use an OMRON CS/CJ-series or CP-series PLC and an XW2Z-200T-4 Connect-
ing Cable to connect the internal PLC power to the PT. Operation may not be correct if any
other PLCs or cables are used.
NV3W-V1/NV4W/NV3Q (RS-232C Models)
Pin 6 changes from NC to RS and pin 7 changes from NC to CS. (These pins are not actu-
ally used.)
xxii
●:
❍:
Blank: Not appraised.
Series
MicroLogix 1000
SLC-5/03
SLC-5/04
CPU222
CPU216
CPU215
CPU214
CPU212
80S
200S
300S
1000S
*2
not manufactured by OMRON. Refer to the connection diagrams for details.
actual PLC.
Direct connection is possible to the CPU Unit of the PLC.
A Communications Unit or a cable to convert signals is required
to connect to these PLCs.
Model Communications method
RS-232C RS-422A
RS-485
●
●
●
❍ ●
❍ ●
❍ ●
❍ ●
❍ ●
●
●
❍
❍
● ●