Parkside PPSK 40 B2 Operation And Safety Notes Translation Of The Original Instructions page 40

HF-arc is not created?
Bad ignition?
Plasma burner is not ready
8
for operation?
Sparks fly upwards, instead of
down through the material?
Initial cut but not completely
drilled through?
Slag formation on interfaces?
Consumables wear quickly?
40
GB
The burner switch is faulty.
„
Soldering point on the burner
„
switch or plug loosened.
Valve/manometer fails.
„
Burner wear parts damaged
„
or worn.
Current switch is
„
switched off.
Air transmission is restricted.
„
Workpiece is not connected
„
to the earthing terminal.
The plasma beam does not
„
penetrate the material.
Burner sleeve is too far
„
8c
away from the material.
Material was probably not
„
earthed properly.
Lifting speed is too quick.
„
Potential connection
„
problem.
Tool/material creates heat.
„
Cutting speed too low or
„
current too high.
Plasma burner component
„
parts are worn ,
8b
.
8e
Performance was
„
overstretched.
Arc control time exceeded.
„
Incorrect plasma burner
„
assembly.
Insufficient air supply,
„
pressure too low.
Faulty air compressor.
„
Replace electrode.
„
Change wear parts.
„
Switch the current switch
„
to "on".
Another indication of this is
„
a green flame. Check the
air supply.
Check the connections.
„
Increase the current.
„
Reduce the gap between the
„
burner sleeve
material.
Check the connection for
„
correct earthing.
Reduce the speed.
„
Check all connections.
„
Allow the material to cool
„
down and then continue
cutting.
Increase the speed and/or
„
, , reduce the current until the
8c 8d
slag has been reduced to a
minimum.
Check and replace worn
„
parts.
Material too thick, increase
„
the angle to avoid material
from being blown back into
the tip.
Do not control the arc for
„
more than 5 seconds. You
can also start with contact
between the burner sleeve
and metal or with a
8c
3 mm distance to the metal.
Check the performance of
„
the external air compressor
and make sure the pressure
is 4–4.5 bar.
and
8c